Aspen FP2082 Universal Peristaltic Pump c/w air sensors

The top-selling Universal is operated by two air temperature sensors.

The peristaltic rotary movement creates a continuous pressure meaning the pump can be sited 8m away from the source with no effect in performance.

Universal Pump peristaltic pump

The Universal Pump peristaltic pump is unique. Integral to the pump are a PCB and two 2-metre sensors, which sense 5°C differential across the evaporating coil to operate the pump. This is a great advantage on systems where anything other than a 240v cooling signal is used.

KEY FEATURES

  • Air temp. sensor operated
  • Remote install possible
  • Pumps contaminated water
  • Can run dry
SUITABILITY
  • Up to 8.5kW / 29,000Btu/h
  • High wall split systems; Ducted units; Floor-standing & Chassis units
  • Perfect for... environments where consistent climate control is critical


Simply connect the pump to the condensate tray (using the vinyl tube supplied). The Universal pump can be mounted remotely as it is self-priming to a height of 3 metres and will pump 6.25 litres of water per hour against a maximum head of 12 metres.

The Aspen Universal is designed to run constantly while the air conditioning system is cooling. By placing the red sensor in the ambient air-on side of the coil and the blue sensor to the air-off the PCB will sense 5°C differential and operate the pump. When the cooling switches off, a 3-minute timer in the pump ensures that the drain tray is emptied before the pump switches off.

The pump is a peristaltic rotary type which means that it is quiet in operation, very reliable and will run dry without fear of damage or any embarrassing noise. It is not sensitive to waterborne contaminants as reciprocating pumps are, and there is no mechanical water sensor to fail.

It is also designed to fit in ceiling voids and lift the condensate water from wall mounted machines where a gravity drain is too obtrusive. It can be used on cassettes fitted with an internal lift pump. The rollers act as check valves to stop condensate draining back into the drip tray.

The universal pump now has a new push-in-plug which makes installation and maintenance easier.


SPECIFICATION

Max. flow:6.5 litres/hr @ 12m head
Max. suction lift:3m
Power supply:230 V AC, 0.2 Amp, 50/60 Hz
Class:I appliance
Max. water temp.40°C
IP protection:IP24
Max. recommended head:12m
Sound level:47 dB(A) @ 1m
Rated:Continuously
Max. AC unit output:8.5 kW
Discharge tube:6mm ID
Safety switch:n/a

Write a review


You may also need